SEARCH OUR RESOURCE CENTER
Electronics are constructed with solid-state components and epoxy-potted. Periodically, check and clean the sensor when used with liquids which cause a coating build-up on the level sensor. No other maintenance is required.
If the pipe or vessel to which the unit is mounted is to be steam-cleaned or cleaned with abrasive detergents, remove the entire unit before cleaning by:
To reinstall, follow installation procedures.
UCL-520 Ultrasonic Continuous Level Transmitter is a two-wire ultrasonic transmitter that provides non-contact level measurement up to 26.2' (7.98 m) and is built for challenging ultra-pure, corrosive or waste liquids. It is easy to install in...
UCL-510 Ultrasonic Continuous Level Transmitter is a non-contact level sensor with no-moving-parts built for general purpose small tank applications 49.2" (1250 mm) or less and offers switch, controller and transmitter capabilities in one...
The XLS-1 Ultrasonic Level Sensor is Gems' rugged alternative to reed switch level sensors. They are compatible with water, water-based and hydrocarbon-based liquids, and are perfect for applications where foam and condensation may affect other...
