Ultrasonic Level Switch Installation

  1. Drill a suitable hole in the vessel or pipe wall and tap for 3/4" NPT. In a thin walled vessel or material not suitable for threading, weld or braze a bushing to accept the level sensor.
  2. Screw the sensor in the threaded section and make sure that there is a good seal. Use a pipe compound or sealing tape to avoid excessive tightening. Do not over tighten.
  3. Run the power and control wiring cables to the electronics control unit.

Ultrasonic-Vertical-Mounting


Featured

Products

UCL-520 Ultrasonic Continuous Level Transmitter

UCL-520 Ultrasonic Continuous Level Transmitter

UCL-520 Ultrasonic Continuous Level Transmitter is a two-wire ultrasonic transmitter that provides non-contact level measurement up to 26.2' (7.98 m) and is built for challenging ultra-pure, corrosive or waste liquids. It is easy to install in...

Learn More About UCL-520 Ultrasonic Continuous Level Transmitter
UCL-510 Ultrasonic Continuous Level Transmitter

UCL-510 Ultrasonic Continuous Level Transmitter

UCL-510 Ultrasonic Continuous Level Transmitter is a non-contact level sensor with no-moving-parts built for general purpose small tank applications 49.2" (1250 mm) or less and offers switch, controller and transmitter capabilities in one...

Learn More About UCL-510 Ultrasonic Continuous Level Transmitter
XLS-1 Ultrasonic Level Sensor

XLS-1 Ultrasonic Level Sensor

The XLS-1 Ultrasonic Level Sensor is Gems' rugged alternative to reed switch level sensors. They are compatible with water, water-based and hydrocarbon-based liquids, and are perfect for applications where foam and condensation may affect other...

Learn More About XLS-1 Ultrasonic Level Sensor